A featured contribution from Leadership Perspectives: a curated forum reserved for leaders nominated by our subscribers and vetted by the Construction Tech Review Advisory Board.

NEBCO, Inc

Shawn Paskevic, CIO, NEBCO

Turning Big Data into Big Money

Shawn Paskevic

Shawn Paskevic

Gartner defines BigData as “high-volume, high-velocity and/or high-variety information assets that demand cost-effective, innovative forms of information processing that enable enhanced insight, decision making, and process automation. ”For NEBCO, Inc., a 108-year old, family-owned company with 1,200 employees across 35 sites, it really is all about the speed and volume of Data flowing throughout the organization--BigData is being generated and consumed by systems and people. At NEBCO, BigData has another V, and that’s Value. BigData adds value by providing the insight needed to obtain operational excellence and laying the foundation for a competitive advantage with value-added service.

NEBCO’s operations span the state of Nebraska and supplyconcrete-related building materials to the construction industry. Products include sand and gravel, limestone, concrete block and pipe, rebar and steel, precast concrete and ready mixed concrete.

BigData brings big challenges... or a: real-time systems integration, highly available systems, and additional staff necessary to support new tools that have taken mobile to a whole new level  

In 2013, NEBCO began installing TrackIt GPS devices and today they are in all 200 of their concrete mixer trucks. While these units provide the basics of any GPS system--location and navigation, they are one of the primary sources of BigData used by the operation. The tight integration of these units with NEBCO’s ready mixed concrete scheduling and dispatching system gives us near real-time status of each delivery. When a flashing red truck appears on his monitor, the dispatcher can contact the customer immediately to let him know that the load is going to be late. We can also receive alerts when a truck is being held too long on the job before the customer is ready to unload.In our business truck hold time is critical because it can negatively impact another customer’s on-time delivery. Last, but not least, we know within seconds when a truck has left the job site, allowing us to begin scheduling its next load.

These devices are also connected to the trucks’ engines, generating data that allows us to be proactive with repairs. Other data captured can be used to analyze truck idle time and fuel economy. With event-triggered alerts, supervisors can be notified at the time of an infraction, such as speeding, and use this information to coach drivers and improve the safety of our vehicles on the road.

Our drivers’ typical day starts with them logging into the device in their truck and effectively clocking in. The clock in and out times are significant pieces of data that can be used to help close the gap between “clocking in” and the driver’s first load, and the time from when the driver returns to the plant after his last load to the time the driver “clocks out.” In addition to capturing valuable data for operations, the device server another purpose: they have eliminated the use of time clocks and manual time collection, resulting in additional cost savings.

In all of these situations, Big Data can be used to optimize our day-to-day operations: providing near real-time status of each truck in the delivery cycle, collecting diagnostic information from the engine to minimize down-time caused by unexpected repairs, analyzing fuel economy and idle truck time, and even improving safety by providing immediate feedback on driver errors.[vendor_first]

Using the Big Data that has been collected to support decision making processes is key. According to Jim Wagner, a subject matter expert with over 50 years of experience in the Ready Mixed Industry, “Driver utilization, a leading performance indicator averages 65 percent. This represents delivery time verses paid time. Non-productive time is composed of start up in the morning, shut down at night, waiting in the plant for a load and waiting on the jobsite to be unloaded. The national average cost per hour of a driver and truck is $65. In an 8-hour day, the driver is productive (delivering) 5.2 hours. Increasing efficiency by just 5 percent would reduce paid hours by 24 minutes per day, a savings of $26 per truck per day.

The articles from these contributors are based on their personal expertise and viewpoints, and do not necessarily reflect the opinions of their employers or affiliated organizations.
Top